Monthly Archives: October 2013

Pin locks in detail

When flat and stable the bridle will pull in "normal" direction.

Since there was way more feedback on my last video than I expected I want to go a little bit more into detail. The described scenarios and pull orientations will most likely not happen in a slider up/ terminal environment, … Continue reading

Posted in Safety | 3 Comments

Pinlocks

pinlock_thumb

Pretty much every rig design out there has some issues that at certain pull directions the pull force increases. This ranges from a little additional force that has to be applied to pop the pin, up to that the pin … Continue reading

Posted in Safety | 3 Comments